HP DesignJet 2500 and 2000CP Printer Quick Reference Guide - C4704-90251
Message Explanations and Actions
87
Initializing
new ink system
In the ink system replacement process, you have swapped an Imaging ink
system for a UV Pigmented ink system, or vice versa. The printer will
reinitialize and prepare to print with the new ink system.
(This message only
applies to firmware revision levels A.02.08 or higher.)
Wait until the new ink system has been initialized.
Ink cartridge
removed ■■❏■→
The printer has detected that one or more ink cartridges have been removed or
cannot be detected, as indicated by the flashing squares.
Press ↓ to check the failing ink cartridge. Printing has been disabled. You
should reseat the ink cartridge immediately; see 72, Checking the Ink
Cartridges. If this does not solve the problem, you will have to replace the
entire ink system (printhead, printhead cleaner, and ink cartridge) using the
Replace Ink System key.
If you don’t correct the error now, you will see the status message “Ink
system error” described on page 89.
Ink cartridge valve
out ■■❏■→
The printer has detected that one or more of the ink cartridge valves (as
indicated by flashing squares) has popped out during refilling.
Press ↓ to check the failing ink cartridge. You should reseat the valves
immediately; see 72, Checking the Ink Cartridges. If this does not solve the
problem, you will have to replace the entire ink system (printhead, printhead
cleaner, and ink cartridge) using the Replace Ink System key.
0HVVDJH ([SODQDWLRQDQG$FWLRQ
qrgbook.bk.fm Page 87 Tuesday, July 28, 1998 5:31 PM