HP DesignJet 2500 and 2000CP Printer Quick Reference Guide - C4704-90251
Message Explanations and Actions
89
INK SYSTEM ERROR
xxxxxx
The printer has detected an error in the ink system, as shown in earlier
messages. Printing will be disabled until the error has been corrected. If more
than one error is pending, the one with the highest number, corresponding to
the most severe error, will be displayed.
Possible error codes (xxxxxx) are:
• 58.... See the message “Incorrect ink system”
• 65.... or 66.... See the message “Printhead failure”
• 67.... See the message “Printhead contact error”
• 72.... See the message “Ink cartridge removed”
• 73.... See the message “Head cleaner removed”
• 74.... See the message “Printhead removed”
• 88.... See the message “Mixed ink system”.
Press the Replace Ink System key to replace the erroneous ink systems in order
to print with your printer again. See 74, If You Have Problems Reseating a
Printhead.
Press the Enter key to access the main front panel menus.
Install complete Ink system replacement has been completed successfully.
Resume normal operations.
Lift lever after
aligning
You have lowered the media lever to align the media with the entry platen.
Lift the lever at the right edge of the paper path on the printer when you’ve
finished aligning the roll media as instructed.
0HVVDJH ([SODQDWLRQDQG$FWLRQ
qrgbook.bk.fm Page 89 Tuesday, July 28, 1998 5:31 PM