HP DesignJet 2500 and 2000CP Printer Quick Reference Guide - C4704-90251

0HVVDJH([SODQDWLRQVDQG$FWLRQV
90
Lift lever to
continue
The media lever was lowered while the processor was busy.
Lift the lever at the right edge of the paper path on the printer.
Load arrow edge
print side down
Remove the accuracy calibration print, turn it so that the edge with the arrows
printed on it is print-side down, then load that edge into the printer.
Load cancelled
Remove media
The Cancel key was pressed while media loading was in progress.
Remove media.
Load error
Remove media
Media was inserted with the media lever raised.
Lower the lever and reload the media.
Load media for
calibration
Load media to proceed with calibration.
Load media
to align printheads
Load media to proceed with printhead alignment.
Load media to
check printheads
The printer is telling you to load media so it can perform the printhead check.
Load media to proceed with printhead check.
Load sheet for
calibration
The printer is ready to perform the accuracy calibration procedure, but media is
not present.
Load media to continue.
Lower lever Lower the lever at the right of the printer.
Lower lever
Remove media
Lower the lever at the right of the printer and remove the media.
0HVVDJH ([SODQDWLRQDQG$ FWLRQ
qrgbook.bk.fm Page 90 Tuesday, July 28, 1998 5:31 PM