HP DesignJet 2500 and 2000CP Printer Quick Reference Guide - C4704-90251

Message Explanations and Actions
93
MIXED INK SYSTEM
88xxxx
The printer has earlier detected components of different ink system types (for
example, Imaging and UV Pigmented). Printing will be disabled until the ink
systems are all of the same type. The error code “88xxxx” indicates a mixed
ink system error.
Press the Replace Ink System key to replace the erroneous ink systems in
order to print with your printer again.
You can press the Enter key to access
the main front-panel menu.
See 74, If You Have Problems Reseating a Printhead.
No code for UV inks
Continue→
The printer does not have the correct firmware for the HP DesignJet CP ink
system UV currently installed.
(This message only applies to firmware
revision levels A.01.xx.)
Press ↓ to continue, and reinstall the HP DesignJet CP Ink System (Imaging
ink system) back into the printer.
Access the menu Utilities / Statistics / Code rev to confirm the firmware
revision present. If you have a code revision like A.01.xx, you need to upgrade
your firmware to code revision A.02.08 or higher to use the HP DesignJet CP
Ink System UV.
Open left door to
access ink cartrg.
You are doing an ink system replacement.
Open the left door to access the ink cartridges.
Open right door to
access head cleaners
You are doing an ink system replacement.
Open the right door to access the printhead cleaners.
0HVVDJH ([SODQDWLRQDQG$FWLRQ
qrgbook.bk.fm Page 93 Tuesday, July 28, 1998 5:31 PM