HP DesignJet 2500 and 2000CP Printer Quick Reference Guide - C4704-90251
0HVVDJH([SODQDWLRQVDQG$FWLRQV
96
Printhead check
cancelled→
The printhead check procedure has failed, or the printer has detected a fault
that stops the procedure from completing. Subsequent messages will explain
the error further:
■ “Replacement of lens cover recommended”—You should check the section
on replacing lens covers on page 10-3, Lens Maintenance in the Users
Guide.
■ “Media too small for calibration”—The roll that is loaded is not wide
enough for the check to be done. It must be at least A3 size. You should load
appropriate media and repeat the check again, using Image Quality /
Printhead Service / Printheads Check / Now. If you use sheet media that is
too small, the printer will reject the media and prompt you to load new
media.
Press ↓ to continue. You may continue printing, but you may not get your usual
image print quality. To fix problems with the ink system, see 74, If You Have
Problems Reseating a Printhead.
0HVVDJH ([SODQDWLRQDQG$FWLRQ
qrgbook.bk.fm Page 96 Tuesday, July 28, 1998 5:31 PM