HP DesignJet 2500/2000CP Printer - User's Guide

Working with Media
Loading Media onto the Take Up Reel accessory
3-22
6 Use a small amount of sticky tape (see note below) to attach the media to the core.
Use three strips, one at each side of the media and one in the middle. Stick the
middle one first.
NOTE:Use only tape which will not tear the media when it is removed later.
NOTE:To avoid the media skewing as it is wound onto the Core tube, ensure the
media is straight when it is attached.
7 Press the
↓
key to advance the media. Enough media should be advanced so that the
media can wrap at least once around the core so securing it fully onto the Take Up
Reel.
C472335
Make sure the media is
straight with no creases
C4704016
Back Media --------->
Forward Media ---->
Advance about this
much media
C472336