488CA Printer - User's Guide

This is the yellow on page 5–15 (seq: 107)

This is the magenta on page 5–15 (seq: 107)Red

5–15

This is the cyan on page 5–15 (seq: 107)

5–15

Company confidential. Genie User’s Guide, Edition 2, First Draft. Freeze Status: open

This is the blue on page 5–15 (seq: 107)

This is the black on page 5–15 (seq: 107)

If the line is not perfectly straight at bias 0 in the test image (see figure above), try

the following:

1 Perform the Black Cartridge Alignment Procedure (see page 5–4) and print the

Print Quality Test Print again to see if there has been any improvement.

2 If the error is still present, replace the failing cartridge and print the Print Quality

Test Print again.

Test 4 (Color Alignment Quality) is in two parts:

The first of the patterns (in the upper line) tests alignment between the cyan and

magenta cartridges; it should be blue with no cyan or magenta shadows. The

second tests alignment between the cyan and yellow cartridges; it should be

green with no cyan or yellow shadows. The third tests alignment between the

magenta and yellow cartridges; it should be red, with no magenta or yellow

shadows.

Correct Incorrect

The lower test patterns check the color alignment; there are six patterns each

with two different primary colors. If there is misalignment between the primary

Correct Incorrect

Special internal prints

Using the Print Quality Test Print

INTERNAL

PRINTS