HP DesignJet 430/450C/488CA Printer - User's Guide

450C/
488CA
This is the yellow on page 7–6 (seq: 124)
This is the magenta on page 7–6 (seq: 124)
This is the cyan on page 7–6 (seq: 124)
7–6
Company confidential. Genie User’s Guide, Edition 2, First Draft . Freeze Status: open
This is the blue on page 7–6 (seq: 124)
This is the black on page 7–6 (seq: 124)
3 Match the color of the cartridge’s label with the color of the dot above the empty
stall. For users with color-vision deficiencies: you can identify the colors of the
cartridges by the part numbers on the boxes—see page 10–19.
a Take the new cartridge out of its box.
b Remove the colored protective tape and tab from the cartridge’s nozzles.
c Make sure that the printer is still switched on. Never install cartridges with the
printer switched off.
d Insert the new cartridge in the stall. Press down lightly and push the cartridge
away from you until it snaps into place. If it is installed correctly, the Ready
light flashes three times.
Yellow
Cyan
Magenta
Black
1
2
1
2
430
450C
488CA
4 When you have finished replacing cartridges, lower the cover.
If you wish, you can now check your cartridge alignment by running the Black
Cartridge Alignment Routine (see page 5–4). However, this is normally only
required for troubleshooting.
Maintaining your printer
Replacing cartridges
Localization Note.