488CA Printer - User's Guide

1–2

Company confidential. Genie User’s Guide, Edition 2, First Draft . Freeze Status: open

This is the blue on page 1–2 (seq: 18)

This is the black on page 1–2 (seq: 18)

Fast track

If you meet all the following requirements:

If you are happy with English as the language for the printer’s internal prints

If you are experienced at installing printers or plotters

If you don’t want to add extra memory

If you are going to connect the printer directly to a PC

If you are going to use a parallel connection

... just follow these five steps, and skip the rest of this chapter.

1 If the printer is without legs, place it at the edge of a stable platform.

Level surface

Leave enough space for your largest

sheet size to hang freely from the media

exit slot without touching the ground

Place the printer at the edge of the sup-

port, so that sheets exit without hitting

the top of the stable platform

2 Connect the power cord and the parallel cable, securing it with the cable clip, and

then switch the printer on.

3 Open the cover and load the supplied print cartridge(s) into the carriage on the left

of the printer. For help, use the label on the printer near the carriage and the

documentation in the cartridge box. Don’t forget to remove the tape from the

cartridge(s).

4 If you haven’t already done so, install the media deflector extensions (as described

in the Printer unpacking and assembly instructions).

Localization Note.

Setting up your printer

Fast track