488CA Printer - User's Guide

1–7

Company confidential. Genie User’s Guide, Edition 2, First Draft. Freeze Status: open

This is the blue on page 1–7 (seq: 23)

This is the black on page 1–7 (seq: 23)

Before handling a memory module, either put on a grounding wrist strap and

attach the end to the metal chassis of the printer, or touch the outer metal

surface of the printer with your hand. Otherwise, static electricity from your

body could damage the memory module.

3 Take the memory module out of its bag, holding the module only by the edges.

4 With the module’s small notch on the left and the metallic edge away from you,

load the module into the slot nearest to you. (The other slot is not for memory

modules.) To do this, first hold the module at an angle, and then gradually push it

back until it clicks into place vertically.

Notch

Push until it clicks into place

Slot nearest to you

5 Replace the cover plate and screws.

Localization Note.

SETUP

CAUTION

Setting up your printer

Task 2: (Optional) Install a memory expansion module