488CA Printer - User's Guide

1–9

Company confidential. Genie User’s Guide, Edition 2, First Draft. Freeze Status: open

This is the blue on page 1–9 (seq: 25)

This is the black on page 1–9 (seq: 25)

Task 4: Switch on

Be sure that the power cord supplied with your printer matches your ac

power connection requirements. Use only three-wire (earth-grounded) power

cords with this printer.

1 Make sure that the power switch on the front of the printer is in the OFF position

(extended).

off

2 Plug the power cord into the socket at the back of the printer, and then into your

power outlet.

3 Switch on the printer, by pushing the power switch.

After you switch on, the printer will execute a self diagnostic test while flashing

each of the lights for a few moments.

4 If there is no sound, nor any light on the front panel, you may have a power

problem. For troubleshooting information, see Chapter 9.

Localization Note.

SETUP

Setting up your printer

Task 4: Switch on

WARNING