488CA Printer - User's Guide

2–18

Company confidential. Genie User’s Guide, Edition 2, First Draft . Freeze Status: open

This is the blue on page 2–18 (seq: 60)

This is the black on page 2–18 (seq: 60)

5 Remove the new roll from its wrapping, place it on the spindle, so that, as the

media winds up from behind the roll, the media stop still on the spindle is on the

right. Push the right media stop so that it is flush against the end of the roll (2 in

the illustration below). Then insert the left media stop on the left end of the

spindle.

6 Put the loaded spindle back in the printer, pushing first the right side into place and

then the left.

Make sure that each end of the spindle slots firmly into place with an audible

“click”.

It is important to make sure that the spindle is firmly in place, otherwise it

could fall off the printer.

Working with media

Loading roll media

Localization Note.

WARNING