HP Designjet 4520 Printer series - Assembly Instructions: English

77 78 79 80
A Gigabit ethernet socket is provided for con-
nection to a network.
Two FireWire ® sockets are provided for direct
connection to computers.
Remove the two yellow plastic screws from the
right and left side of the paper feed. Caution: Be
very careful when removing.
Remove the two yellow plastic screws from the
left and right side of Drawer 2. Caution: Be very
careful when removing.
Using the cable supplied, connect the roll mod-
ule to the printer.
81 82 83 84
Wait until you see this message (~10 minutes).
Highlight your language using the Up and
Down keys. Press the Select (ü) key.
Plug the power cable into the rear of the printer,
then plug the other end into the AC power outlet.
Turn the power switch at the rear of the printer to
the on position.
If the power light on the front panel remains off,
press the Power key to switch on the printer.
Note: This printer is Energy Star compliant and
can be left switched on without wasting energy.
Leaving it on improves response time and overall
system reliability.
CM768-900011.indd 11 03/02/2009 17:12:34