HP Designjet 4520 Printer series - Assembly Instructions: English

45 46 47 48
Slide Drawer 1 forwards to gain better access
for the front screw. Fix the left side of the stand
to the printer using two screws. Make sure that
the screws are fully tightened.
Advance warning: in the next step, make sure
you position the stand pins in the holes in the
center of the printer body brackets.
Lift the stand assembly onto the printer body.
The anti-slip material should face to the rear of
the printer.
Fix the right side of the stand to the printer using
one screw. Make sure that the screw is fully
tightened.
Left Leg
Right Leg
x2
49 50 51 52
Remove the roll module from the plastic bag.Before unpacking the roll module, note that you
should only handle this piece of equipment using
the points indicated by the arrows shown
above.
Open the box containing the roll module, then
remove the two foam supports.
Remove the roll module from the packaging box.
IMPORTANT INFORMATION
x4
CM768-900011.indd 7 03/02/2009 17:12:29