HP Designjet 4520 Printer series - Assembly Instructions: English

53 54 55 56

Before the roll module is moved into its nal po-

sition, please note that it should sit on the pins

that were located on the stand legs earlier.

Remove the remaining two yellow plugs from the

left and right legs. It is important to remember

the positions of these holes.

Turn the roll module over into an inverted posi-

tion as shown above. Then carry it to the front of

the inverted printer.

Rest the roll module next to the rst printer

crossbar.

x4x4

Rear of printer

57 58 59 60

Fix the roll module to the left leg of the stand

using two collar-headed screws.

Three people are needed, two at the front and

one at the rear of the printer. The two at the front

should lift the roll module and then, with the help

of the third person at the rear, lower it vertically

onto the pins located earlier on the stand.

Look at the front of the roll module and check

that it comes close to the legs of the stand

Fix the roll module to the right leg of the stand

using two additional screws.

CM768-900011.indd 8 03/02/2009 17:12:30