HP Designjet L25500 Printer Series - Site preparation guide (second edition)

Figure 2-1 Electrical configuration diagram
Wall receptacles and power cords
Two power cords are provided with your printer, according to the printer's electrical specifications. If
those cords do not reach your PDU and/or UPS, a certified electrician must install suitable extension cables
on the day of installation.
To make sure you have the right wall socket outlets (wall receptacles) ready for installation, check the
following:
1. The wall socket outlets must be suitable for printer input ratings. See
Single phase power
on page 4.
2. The wall socket outlets must be suitable for the power cord plug type used in the country of
installation.
Table 2-6 60 inch printer power cord specifications on page 6 and Table 2-7 42
inch printer power cord specifications on page 7 list several examples of the power cords and
the plugs provided with the printer according to the country. To make sure you have the right wall
receptacle, find your country in the appropriate table and check the plug type.
WARNING! Use only use the power cord supplied by HP with the printer. Do not use a power
strip (relocatable power tap) to connect both power cords. Do not damage, cut or repair the power
cord. With a damaged power cord, there is risk of fire and electric shock. Always replace a
damaged power cord with an HP-approved power cord.
Table 2-6 60 inch printer power cord specifications
Country HP Part Number * Length Plug type Plug
USA, Canada, Mexico,
Japan, Philippines,
Thailand
8120-6893 4.5 m NEMA 6-20P, 240 V,
20A, non-locking
6 Chapter 2 Site preparation requirements ENWW