HP Designjet L25500 Printer Series - Site preparation guide (second edition)

Electrical installation requirements Yes No Comments
Are the wall receptacles (wall sockets) placed close enough to the printer that
the plugs can be plugged and unplugged easily?
NOTE: The power cord length is 14.8 ft (4.5 m) for 60-in printers, and 8.2
ft (2.5 m) for 42-in printers.
(Required)
Would the printer's built-in Residual Current Circuit Breaker (also known as
Ground Fault Circuit Interrupter) operate in the case of a current leakage fault
to the product chassis (even if an isolation device is installed)?
(Required)
Electrical configuration requirements Yes No Comments
Do you need an Uninterrupted Power Supply (UPS) or step-up transformer? If
so, is it correctly installed?
Networking and computer requirements Yes No Comments
Is the RIP computer and software ready for installation?
Have network connections been supplied?
Do you have a color sensor that is compatible with your RIP?
Do you have a LAN cable long enough to connect the printer to the network?
Environmental requirements Yes No Comments
Have the temperature and humidity requirements been satisfactorily met in the
print production area, and is there adequate ventilation or air conditioning?
Have the temperature and humidity requirements been satisfactorily met in the
storage area?
Is the print production area free from dirt and dust?
Does the print production area have sufficient lighting?
Other requirements Yes No Comments
Have you arranged for supplies such as substrate and ink cartridges to be
available on the day of installation?
Have you met the requirements specified in this guide? (Required)
ENWW 11
Checklist