HP Designjet L25500 Printer Series - Site preparation guide (second edition)

1 Overview
Introduction
This Site preparation guide should be used for HP Designjet L25500 printers, both 42 inch and 60 inch.
Specifications and requirements are stated for both printer widths wherever necessary.
Your printer is supplied ready to use after a few simple installation procedures described in detail in
the Assembly instructions. It is important to read the information provided in this guide thoroughly and to
ensure complete compliance with all installation and operation requirements, safety procedures,
warnings, cautions and local regulations. A well prepared site helps to provide a smooth and easy
installation.
Customer responsibility
You are responsible for all preparations of the physical site to install and place the printer:
●
Prepare the building's electrical system used to power the printer to meet the printer's requirements
and the Electrical Code requirements according to the local jurisdiction of the country where the
equipment is installed, and power up the printer on the day of installation. See
Electrical
configuration on page 4.
NOTE: Make sure a certified electrician reviews the setup and configuration of the electrical system
used to power the printer. See
Electrical configuration on page 4.
●
Meet temperature and humidity requirements and ensure proper ventilation for the printer. See
Environmental specifications on page 3.
●
Meet all RIP requirements, networking and printing supplies. See
RIP workstation characteristics
on page 4, Networking on page 4 and Printing supplies on page 4.
●
Prepare the unloading route so the printer can be unloaded and maneuvered into place. See
Unloading route on page 2.
Installation time schedule
Allow a minimum of three hours for the installation. The installer may require the help of three people to
perform certain tasks during installation.
ENWW
Introduction
1
Overview