HP Designjet L25500 Printer Series - Site preparation guide (second edition)

60-in printer 60–in printer (Japan

only)

42-in printer

Maximum power consumption 4.8 kW (overall consumption

for both power cords)

4.8 kW (overall consumption

for both power cords)

3.5 kW (overall consumption

for both power cords)

Maximum load current (per

power cord)

15 A 15 A 13 A

Active power consumption 2.6 kW 2.6 kW 1.8 kW

WARNING! Ensure that the printer's built-in Residual Current Circuit Breaker (also known as Ground

Fault Circuit Interrupter) operates in the case of a leakage current fault to the product chassis, even when

an isolation device (such as an isolating transformer) is used to supply power to the printer.

CAUTION: Ensure that the input voltage is within the printer's rated voltage range. The 60-in printer

requires a step-up transformer for tri-phase 208 V or 200 V power systems (voltage line to line).

Circuit breakers

NOTE: The circuit breakers must meet the requirements of the printer and shall be in accordance with

the Electrical Code requirements of the local jurisdiction of the country where the equipment is installed.

The printer requires two dedicated lines, each protected by a branch circuit breaker according to the

rating of the wall socket outlet.

Table 2-5 Circuit breaker specifications

Branch circuit breaker Quantity

Single phase line 2 poles, 16 A * (20A for NEMA 6-20R

wall socket)

2, one for each dedicated line

* Rating according to wall socket outlet

NOTE: The Power Distribution Unit (PDU) must be rated to meet the power requirements of the printer,

and shall be in accordance with the Electrical Code requirements of the local jurisdiction of the country

where the equipment is installed.

Table 2-4 Single phase line specifications (continued)

ENWW

Electrical configuration

Requirements