HP Designjet T7200 42 in Production Printer - Introductory Information
Introductory Information
12. OK key: to conrm an action while in a procedure or interaction. To enter in a submenu in the menu. To select a value
when given an option. If the status screen is displayed, this key takes you to the main menu.
13. Status light: indicates the printer’s status. If the status light is solid green, the printer is ready. If it is ashing green,
the printer is busy. If it is solid amber, there is a system error. If it is ashing amber, the printer needs attention.
Front-panel error messages and codes
If an error message appears on the front panel that is not included in this list, and you are in doubt about the correct
response, turn o the printer and then turn it back on. If the problem persists, contact HP Support. See Using your printer.
Error message or code Recommendation
[Color] cartridge has expired Replace the cartridge.
[Color] cartridge is incorrect Replace the cartridge by one supported in this region.
[Color] cartridge is missing Insert a cartridge of the correct color.
[Color] cartridge is out of ink Replace the cartridge.
[Color] printhead #[n] error: please remove Remove the incorrect printhead and insert a new printhead of the
correct type (color and number).
[Color] printhead #[n] error: replace Remove the non-functional printhead and insert a new printhead.
Faulty cartridge. Replace [color] cartridge Replace the cartridge.
PDL Error: Ink system not ready Clean the printheads.
Replace [color] cartridge Replace the cartridge.
Reseat [color] cartridge Remove and reinsert the same cartridge.
26.n.01 (where n = the ink cartridge number) Remove ink cartridge n and reinstall it in the printer. If the error
persists, replace the ink cartridge. If the problem persists, contact
HP Support.
29.01 The maintenance cartridge is not inserted correctly.
• Open the maintenance cartridge door on the right side of the
printer, make sure that the maintenance cartridge is correctly
seated, and then close the door.
• If the problem persists, replace the maintenance cartridge.
If the problem persists, contact HP Support.
SE 39.n:01.2 (where n = the roll number) Unable to load roll n from standby/parking position; roll
mispositioned. Roll n has been unloaded. Reload it and check that the
paper is correctly aligned with the hubs.
SE 39.n:01.3 (where n = the roll number) Unable to load roll n from standby/parking position; paper edges
were not found. Roll n has been unloaded. Reload it.
SE 40:03 A roll loading error has occurred.
• Turn the power o at the rear of the printer and disconnect the
power cord.
• Open the Smart Roll-loading System and check for any visible
obstacles restricting its movement.
• Reconnect the power cord and turn on the printer.
If the problem persists, contact HP Support.
3