Manualshelf

HP StorageWorks Management Pack for System Center Operations Manager 2007 Installation and User Guide

ManualsBrandsHP ManualsSoftwareHP EVA3x00/4x00/5x00/6x00/8x00 VDS and VSS 2.0 Hardware Providers
11121314151617181920
• HP Storage XP 48, 128, 256, 1024, 12000, and 24000 Arrays, and HP XP Device Management
Software
NOTE:
Supports either CV XP or CV XP AE, but not both together.
• HP Storage ESL E-Series, EML E-Series, ESL 6000/9000/12000, and MSL Series, and HP Tape
Device Management Software
• HP Storage B-series Switches and HP B-series Switch Device Management Software
• HP Storage P4000 SAN/iQ 8.5, 9.0, and 9.5
• HP E5000 Messaging System
• HP X5000 System
• HP 3PAR Storage System
Pre-installation Setup Activities for SNMP
Your system consists of an OpsMgr 2007 Management Server and one or more agents. If the system
is directly monitored by root management servers, the agent installation is not required. The agents
are listed in the Computers tab of the Administrator console in the OpsMgr 2007 Management Server.
You can add new agents using the Discovery wizard in the OpsMgr 2007 Administrator Console.
You must install the SNMP Trap Catcher Service on all agents before you start sending SNMP messages
to the agents.
Installing the SNMP software
If your SNMP and OpsMgr 2007 Management Server is installed on the same system, you must install
the SNMP WMI Provider and ensure that snmp.exe and snmptrap.exe services are running.
Complete the following steps to install the SNMP WMI Provider for Microsoft Windows Server 2003:
1. Open the Windows Control Panel.
2. Double-click Add/Remove Programs.
3. Click Add/Remove Windows Components.
4. From the Windows Components Wizard window, select the Management and Monitoring tools
option.
Click Details.
5. Select Simple Network Management Protocol and WMI SNMP Provider.
Click OK.
6. On Windows Component Wizard window, click Next to install selected options.
7. Installation wizard starts and after the successful installation, click Finish to complete the installation.
Complete the following steps to install the SNMP WMI Provider for Microsoft Windows Server 2008
or later:
1. Double-click Administrative Tools > Server Manger.
2. Click Features on the Service Manager page.
3. Click Add Features, the Add Features Wizard appears.
HP Storage Management Pack for System Center User Guide 17