HP StorageWorks Management Pack for System Center Operations Manager 2007 Installation and User Guide

To configure WEBES/SEA to send an XML event callout to a particular host port pair where the
WEBESEventListener service is listening, complete the following steps on the WEBES/SEA installed
host:
1. Start the WEBES desta service at the command line using desta start. You can also start the
service from the Windows Start menu.
2. Enable OpsMgr 2007 support, by entering the following command: desta mom on
The system prompts you to enter host name and port of the system where you want to send the
XML callout information.
NOTE:
Turning desta mom OFF and ON displays the OpsMgr 2007 node name (IP address).
For more information about installing and configuring WEBES/SEA, see the following website: http:/
/h18023.www1.hp.com/support/svctools/webes/
NOTE:
If you want to change the default TCP port number (8945), enter the new port number. After you install the WEBES
Listener installation, change the port number in the config.txt file located in the C:\Program Files\HP\HP
Enterprise Storage directory for a 32–bit operating system, and C:\Program Files(x86)\HP\HP Enterprise Storage
directory for a 64–bit operating system. Stop and restart the WEBES Listener service.
For more information, see Figure 4
Figure 4 Enabling OpsMgr 2007 within WEBES
.
Sending Event Messages
WEBES (6.1 or later) sends event messages through XML report to a particular host and port.
Installing WMI
WMI Support Matrix
To receive the events from E5000 Messaging System and X5000 System, WMI service should be
running on both the system.
HP Storage Management Pack for System Center User Guide 19