HP StorageWorks Management Pack for System Center Operations Manager 2007 Installation and User Guide

7. [Optional] Enter System Contact information.
Normally this will be network administrator information such as email address, or phone number
for the person you would contact if you could not connect to SNMP clients.
Adding an SNMP client
In the Access Control section, click Add to add an SNMP client. This SNMP client can be used to view
SNMP.
You can add SNMP clients by specifying either IP addresses or host names in the following manner:
• By IP address:
1. Select "By Address" and type the IP address.
2. Select an IP Netmask from the list. Select Single Host if adding only one SNMP client.
3. Click OK. The IP address and netmask entry appear in the Access Control list.
4. Click OK in the Edit SNMP Settings window to finish.
• By host name:
1. Select "By Name" and type a host name. That host name must exist in DNS and the NSM
must be configured with DNS for the client to be recognized by the host name.
2. Click OK.
The host name appears in the Access Control list.
3. Click OK in the Edit SNMP Settings window to finish.
Enabling SNMP traps
You must add a Trap Community String for client-side authentication. To add a Trap Community String
complete the following steps:
1. Log in to the storage node and expand the tree.
2. Select the SNMP category from the tree.
3. Select the SNMP Traps tab.
4. Click SNMP Trap Tasks and select Edit SNMP Traps.
5. Click Add to add trap recipients.
6. Enter the IP address or hostname for the SNMP client receiving the traps.
7. Click OK.
8. Repeat Step 5 through Step 7 for each host in the trap community.
9. Click OK on the Edit SNMP Traps window when you are finished adding hosts.
Getting SNMP Traps from HP 3PAR Storage System
The SNMP agent of the HP 3PAR Storage System converts all system alerts and alert state changes
into SNMPv2 traps and forwards them to all registered SNMP management stations.
Follow the steps to register the OpsMgr to the SNMP agent of the HP 3PAR Storage System:
1. Login to the HP 3PAR Storage System array through CLI.
2. Type the addsnmpmgr command for setting the trap recipient address.
For example:
HP Storage Management Pack for System Center User Guide 49