HP StorageWorks Management Pack for System Center Operations Manager 2007 Installation and User Guide

addsnmpmgr [options <arg>] <manager_IP>

•

[options <arg>]

–p <port_number>

Specifies the port number where the SNMP manager receives traps. This option is used

if the port number differs from the default of 162.

–pw <password>

Specifies the SNMP manager’s access community string (password), using up to 32 al-

phanumeric characters. If unspecified, the agents send traps without an access password.

–r <retry>

Specifies the number of times to send a trap (

<retry>

) using an integer from 1 through 15 if the SNMP manager is not available. If not spe-

cified, the number of times a trap is sent defaults to 2.

–t <timeout>

Specifies the number of seconds to wait before sending a trap (

) using an integer from 1 through 300. If not specified, the time defaults to 200 seconds.

•

<manager_IP>

a. Manager_IP address is the OpsMgr server IP address.

NOTE:

You need access to all domains in order to run this command.

After successfully completing these steps, HP 3PAR Storage System traps will be forwarded to OpsMgr

server.

Getting SNMP Traps from B-series Switches

To get SNMP traps from B-series switch, complete the following steps:

1. Login to B-series Switch using CLI.

2. Type the snmpConfig command for setting the traps and trap recipient address.

For example:

snmpConfig set mibCapability to turn on or off certain MIBS and Traps

snmpConfig --set mibCapability

FE-MIB : YES

SW-MIB:YES

FA-MIB:YES

FICON-MIB: YES

HA-MIB: YES

SW-TRAP: YES

swFCPortscn: YES

swEventtrap: YES

snmpConfig --set snmpv1

28 Installing Management Pack

SNMP community and trap recipient configuration:

Community (rw): [Secret C0de]

Trap Recipient's IP address : [0.0.0.0] 15.146.152.116

Configuration for monitoring device50