Fabric OS Troubleshooting and Diagnostics Guide v7.0.0 (53-1002150-02, June 2011)

94 Fabric OS Troubleshooting and Diagnostics Guide
53-1002150-02
Diagnostic Port
10
Remote WWNN: 10:00:00:05:33:13:2f:b5
Remote port: 2
Mode: Automatic
Start time: Wed Feb 2 01:41:43 2011
End time: Wed Feb 2 01:43:23 2011
Status: RESPONDER
=============================================================================
Test Start time Result EST(secs) Comments
=============================================================================
Electrical loopback 01:42:08 PASS --
----------
Optical loopback 01:42:16 RESPONDER -- See
remote port results
Link traffic test 01:43:15 RESPONDER -- See
remote port results
=============================================================================
Roundtrip link latency: 1108 nano-seconds
Estimated cable distance: 20 meters
7. To display a summary of the D_Port, use the portdporttest command with the --show all
operand.
switch:admin> portdporttest --show all 42
Port State SFP Capabilities Test Result
=============================================
24 ONLINE E,O PASSED
26 ONLINE E,O RESPONDER
33 OFFLINE --- RESPONDER
8. Optional: Restart the test on both switches if one of the switches reboots, or if the test does
not complete on one of the switches. Perform a portdporttest --stop command and restart the
test with the portdporttest --start command on both switches.
Disabling D_Port
To disable D_Port, perform the following tasks.
1. Disable Port 1 on Switch A, using the portdisable 1 command.
switchA:admin> portdisable 1
2. Disable the D_Port on Port 1 on Switch A, using portcfgdport --disable 1.
switchA:admin> portcfgdport --disable 1
3. Repeat steps 1 and 2 for Port 2 on Switch B.
switchB:admin> portdisable 2
switchB:admin> portcfgdport --disable 2
4. Enable Port 1 on Switch A using the portenable command.
switchA:admin> portenable 1
5. Enable Port 2 on Switch B using the portenable command.
switchB:admin> portenable 2