Fabric OS Troubleshooting and Diagnostics Guide v7.0.0 (53-1002150-02, June 2011)

Fabric OS Troubleshooting and Diagnostics Guide 55

53-1002150-02

Troubleshooting the firmwareDownload command

A network diagnostic script and preinstallation check is a part of the firmwareDownload procedure.

The script and preinstallation check performs troubleshooting and automatically checks for any

blocking conditions. If the firmware download fails, refer to the Fabric OS Message Reference for

details about error messages. Also see, “Considerations for downgrading firmware” on page 56.

If a firmware download fails in a director, the firmwareDownload command synchronizes the

firmware on the two partitions of each CP by starting a firmware commit operation. Wait at least 15

minutes for this commit operation to complete before attempting another firmware download.

If the firmware download fails in a director or enterprise-class platform, the CPs may end up with

different versions of firmware and are unable to achieve HA synchronization. In such cases, issue

the firmwareDownload -s command on the standby CP; the single mode (-s) option allows you to

upgrade the firmware on the standby CP to match the firmware version running on the active CP.

Then re-issue the firmwareDownload command to download the desired firmware version to both

CPs. For example, if CP0 is running v6.3.0 on the primary and secondary partitions, and CP1 is

running v7.0.0 on the primary and secondary partitions, then synchronize them by issuing the

firmwareDownload command.

NOTE

Some of the messages include error codes (as shown in the following example). These error codes

are for internal use only and you can disregard them.

Port configuration with EX ports enabled along with trunking for port(s) 63, use

the portCfgEXPort, portCfgVEXPort, and portCfgTrunkPort commands to remedy this.

Verify blade is ENABLED. (error 3)

Gathering additional information

You should follow these best practices for firmware download before you start the procedure:

• Keep all session logs.

• Enter the supportSave or the supportShow command before and after entering the

firmwareDownload command.

• If a problem persists, package together all of the information (the Telnet session logs and

serial console logs, output from the supportSave command) for your switch support provider.

Make sure you identify what information was gathered before and after issuing the

firmwareDownload command.

USB error handling

Table 11 outlines how the USB device handles errors under specific scenarios and details what

actions you should take after the error occurs.