HAFM SW 08.08.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CH-TE, August 2006)

SANtegrity Security Center194
If the Enable IP Access Control List check box is selected, the restricted access to the follow IP
addresses is enforced. If not checked, management interfaces can access the switch from any IP
address. The check box is enabled only if at least one IP address is in the list.
Adding a new IP address
1. Click Add.
The Add/Edit IP Address or Range dialog box is displayed.
2. Enter an IP Address or an IP Address Range.
The IP range is defined by a starting IP address and ending IP address.
3. Click Apply.
Editing one IP address or one range of IP addresses
1. Click Change.
The Add/Edit IP Address or Range dialog box is displayed.
2. Change the IP address or IP Address Range.
3. Click Apply.
NOTE: If multiple IP addresses or ranges are selected, Edit is disabled.
Removing multiple IP addresses at one time
After adding, changing or removing IP addresses, to set the IP Access Control List, perform one of
the following:
• Click Apply and the changes are reflected for that switch in the Product Configuration table.
• Click Apply To and a dialog box with a list of switches is displayed.
• Click Reset and all the changes are dropped and the settings revert to the values that were set
before the changes.
The IP address of the HAFM appliance is not a default included in this list. When accessing the IP
ACL tab, the Enable IP ACL check box is not selected. You cannot remove the server IP address
from the Permitted IP Addresses list while the Enable IP ACL check box is selected. To remove the
server IP from the list, disable the IP ACL.
Applying changes and confirmation
1. Click Apply from the IP ACL tab.
The Security Change Confirmation and Status dialog box is displayed.
This dialog box is similar in behavior to the Security Change Confirmation and Status that is
displayed from the Users tab. The only difference is in the Detailed Changes table. This table
displays the difference between the current settings of IP ACL tab and to-be-populated new
settings.
2. Click Apply or Apply To even if there are no security settings being changed.