HAFM SW 08.08.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CH-TE, August 2006)

HA-Fabric Manager user guide 207
BTroubleshooting
This appendix provides troubleshooting information for the following:
• Problems with discovery, page 207
• Problems with products, page 209
• Problems with addresses, page 209
• Miscellaneous problems, page 216
• Problems with zoning, page 217
Problems with discovery
Table 24 describes possible problems with discovery and suggested resolutions.
Table 24 Discovery problems and resolutions
Problem Resolution
Discovery is turned off. Select Discover > On.
Devices are not being
discovered.
Ensure that your SNMP communication parameters are
set correctly in order to discover switches.
Discovered devices are not
being displayed.
Specify each device in the Out-of-Band dialog box,
either by the individual IP address or by subnet.
1. Select Discover > Setup.
2. Add, change, and remove IP addresses, as
necessary. See ”Configuring IP addresses and
community strings” on page 86.
3. Select IP addresses from the Available Addresses list
and add them to the Selected Subnets or Selected
Individual Addresses lists by clicking . If you add
addresses to the Selected Subnets list, select a
method (Broadcast or Sweep).
4. Click OK.
Ensure that you’ve selected to view the fabric that
includes the discovered devices.
Ensure that only one copy of the application is being
used to monitor and manage the same devices in a
subnet.
Cannot see HBA in discovery
setup bos
HAFM requires specific HBA driver levels. Verify driver
levels.