HAFM SW 08.08.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CH-TE, August 2006)

Informational and error messages240
Cannot install firmware to
a switch with a failed CTP
card.
Firmware cannot be
installed on a switch with
a defective CTP card.
Note that the CTP card is not a
FRU. If it fails, the switch must be
replaced. After replacement, retry
the firmware install to the switch.
Cannot modify
director/switch speed.
Ports speeds cannot be
configured at a higher
data rate than the
director/switch speed.
Port speeds cannot be
configured at a higher
data rate than the
director speed. This
message is displayed
when you set director
sped to 1 GB/sec
through the Configure
Switch Parameters dialog
box and at least one of
the ports is running at 2
Gb/sec.
Either return the director speed to 2
Gb/sec or configure all port data
speeds to 1 Gb/sec through the
Configure Ports dialog box.
Cannot perform this
operation while the switch
is offline.
This operation cannot
take place while the
director or switch is
offline.
Configure the director or switch
offline through the Set Offline State
dialog box and then retry the
operation.
Cannot retrieve current
SNMP configuration.
The director SNMP
configuration cannot be
retrieved by the Element
Manager because the
Ethernet link is down or
busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot retrieve
diagnostics results.
Director diagnostic results
cannot be retrieved by the
Element Manager
because the Ethernet link
is down or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot retrieve
information for port.
Port information cannot
be retrieved by the
Element Manager
because the Ethernet link
is down or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot retrieve port
configuration.
The port configuration
cannot be retrieved by the
Element Manager
because the Ethernet link
is down or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Table 30 Element Manager messages (continued)
Message Description Action