HAFM SW 08.08.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CH-TE, August 2006)

Informational and error messages244
Cannot start port
diagnostics.
Port diagnostics cannot
be started at the Element
Manager because the
Ethernet link is down or
busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot swap an
uninstalled port.
A port swap cannot be
performed when the port
card is not installed.
Perform a swap only on a port that
is installed.
Click OK to remove all
contents from log.
This action deletes all
contents from the selected
log.
Click OK to delete the log contents
or click Cancel to cancel the
operation.
Connection to
management server lost.
Click OK to exit
application.
The HAFM application at
a remote workstation lost
the network connection to
the HAFM appliance.
Start the HAFM application to
connect to the HAFM appliance.
Continuing may overwrite
host programming.
Continue?
Configurations sent from
the host can be
overwritten by HAFM.
Continuing will activate the current
configuration, which may have
been configured by a FICON host.
Could not export log to
file.
A log file I/O error
occurred and the file
could not be saved to the
specified destination. The
disk can be full or write
protected.
Ensure file name and drive are
correct.
Could not find firmware
file.
Firmware file selected
was not found in the FTP
directory. Or, the selected
file is not a firmware file.
Ensure file name and directory are
correct. Or, obtain a valid firmware
file from your service
representative.
Could not remove dump
files from server.
Dump files could not be
deleted from the HAFM
appliance because the
link can be down, or the
HAFM appliance or
Element Manager is busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Could not stop port
diagnostics.
Port diagnostics could not
be stopped by the
Element Manager
because the Ethernet link
is down or busy, or
because the director is
busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Table 30 Element Manager messages (continued)
Message Description Action