HAFM SW 08.08.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CH-TE, August 2006)

HA-Fabric Manager user guide 253
Maximum number of
versions already installed.
The number of firmware
versions that can be
defined to the HAFM
application’s firmware
library (eight) was
reached.
Delete an existing firmware version
before adding a new version.
No file was selected. Action requires the
selection of a file.
Select a file.
No firmware version file
was selected.
A file was not selected in
the Firmware Library
dialog box before an
action, such as modify or
send was performed.
Click a firmware version in the
dialog box to select it, then perform
the action again.
No firmware versions to
delete.
There are no firmware
versions in the firmware
library to delete, therefore
the operation cannot be
performed.
Informational message only—no
action is required.
Nonredundant director
must be offline to install
firmware.
For directors, if the
director has only one CTP
card, the director must be
set offline to install a
firmware version.
For switches, since the
switch has only a single
CTP card, it must be
offline to initiate a
firmware installation.
Note that the CTP card is
an internal component
and not a FRU.
Set the director or switch offline
and install the firmware.
Not all of the optical
transceivers are installed
for this range of ports.
Some ports in the
specified range do not
have optical transceivers
installed.
Use a port range that is valid for
the ports installed.
Open Trunking is not
installed for this product.
Please contact your sales
representative.
The Open Trunking
feature key has not been
enabled. This message is
displayed if the optional
Open Trunking feature is
installed.
Enter the feature key into the
Configure Feature Key dialog box
and enable the key. If you require a
feature key, see your account
representative.
Table 30 Element Manager messages (continued)
Message Description Action