HAFM SW 08.08.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CH-TE, August 2006)

HA-Fabric Manager user guide 257
The data collection
process has been
aborted.
You aborted the data
collection procedure.
Verify the data collection
procedure is to be aborted, then
click OK to continue.
The default zone must be
disabled to configure.
The message is displayed
when you attempted to
change the management
style to Open Fabric and
the default zone is
enabled.
Disable the default zone and
repeat the operation.
The Ethernet link
dropped.
The Ethernet connection
between the HAFM
appliance and the
director is down or
unavailable.
Establish and verify the network
connection.
The firmware file is
corrupted.
A firmware version file is
corrupt.
Contact the next level of support to
report the problem.
The firmware version
already exists.
This firmware version
already exists in HAFM
appliance’s firmware
library.
Informational message only—no
action is required.
The following parameters
cannot be disabled while
Enterprise Fabric Mode is
active: Insistent Domain
ID, Rerouting Delay,
Domain RSCNs.
You attempted to disable
these parameters in the
Configure Switch
Parameters dialog box
while Enterprise Fabric
Mode is enabled.
Disable Enterprise Fabric Mode
through the Enterprise Fabric Mode
dialog box in HAFM, then disable
the parameters.
The link to the director is
not available.
The Ethernet connection
between the HAFM
appliance and the
director is down or
unavailable.
Establish and verify the network
connection.
The link to the switch is
not available.
The Ethernet connection
between the HAFM
appliance and the switch
is down or unavailable.
Establish and verify the network
connection.
The IPL configuration
cannot be deleted.
Deletion of the IPL
address configuration
was attempted and was
not allowed.
Cancel the operation.
Table 30 Element Manager messages (continued)
Message Description Action