HAFM SW 08.08.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CH-TE, August 2006)

HA-Fabric Manager user guide 77
Configuring remote management access
To specify the network addresses that can access the appliance:
1. Select SAN > Remote Access.
The Remote Access dialog box is displayed (Figure 36).
Figure 36 Remote Access dialog box
2. Select Allow remote management sessions to allow others to access the appliance remotely.
3. Enter the maximum number of remote sessions you want to allow.
4. Select whether to allow all or some network addresses to connect.
5. If you select Only network addresses below to connect or All network addresses EXCEPT those
below to connect, enter the appropriate addresses in the Network Address field.
• To add an address, click Add, enter a network address, and then click OK.
• To remove an address, highlight the address in the table and click Remove.
6. Click OK.
Disconnecting a user
To disconnect a use:
1. Select SAN > Active Sessions.
The Active Sessions dialog box is displayed.