FW 05.01.00 and SW 07.01.00 HP StorageWorks Embedded Web Server User Guide (AA-RTDRB-TE, June 2003)

Operating and Managing Products and Parts
106 Embedded Web Server User Guide
Resetting Product Configuration to Default Values
Choose Operations from the navigation panel. Choose the Switch or Director
tab as appropriate. Choose the Reset Config tab; the Reset Config tab view
displays (Figure 36). You can use this view to reset product configuration values.
This enables you to reset all configuration data and nonvolatile settings to the
factory default values including any data that was created from the Configure
page and associated tabs.
Figure 36: Resetting product to default values
Note: You may be asked by service personnel to perform this operation to resolve
system problems. Be sure to review the information in this section completely before
performing this operation.
For a list of factory default values, refer to the product’s installation and service
manual.
Caution: This operation will reset all configuration data and non-volatile
settings to the factory default values. All optional features will also be disabled.
You will need to activate optional features after completing the product reset.