FW 07.00.00/HAFM SW 08.06.00 HP StorageWorks HA-Fabric Manager Appliance Installation Guide (AA-RU5FC-TE/958-000324-002, March 2005)
You can configure the public LAN connection (LA N 1) using one of the following
methods:
• Use Dynamic Host Control Protocol (DHCP) to assign the HAFM appliance
IP address, subnet mask, a nd default gateway IP address. You can either
auto-detect or manually select the DNS server IP address.
• Manually enter the HAFM appliance IP address, subnet mask, default gateway
IP address, and DNS server IP address.
Configuring public LAN addresses using DHCP
To configure TCP/IP network information for the private LAN connection (LAN 1):
NOTE:
Befor e starting this procedur e, ensure that the LAN 1 interface is physically connected
to the LAN. An LCD d isplay of 0.0.0.0 indicates a physical LAN connection is not
present.
1. At the LCD panel, press ENTER. The Welcome!! or o perational information
message changes to the following (Figure 16):
Figure 16 LCD panel (Input Password)
2. Using the
button to increm ent a digit, the button to decrement a digit,
the
button to move the cursor left, and the button to move the cursor
right, input the default password (9999), then press ENTER.TheLAN 1
Setting?? message is displayed at the LCD panel.
3. Press ENTE R a nd the following message is displaye
d(Figure 17) to a llow
the selection of DHCP.
Figure 17 LCD panel (D HCP selection)
4. Usethearrowkeysasdescribedinstep2andselectYE S to use DHCP, then
press ENTER. The following message is displayed (Figure 18):
HP StorageWorks HA-Fabric Manager Appliance installation guide F W07.00.00/HAFM
SW 08.06.00
33