McDATA 4Gb SAN Switch for HP p-Class BladeSystem User Guide (AA-RW20B-TE, December 2005)

McDATA® 4Gb SAN Switch for HP p-Class BladeSystem user guide 171
Set Port command
Description Sets port state and speed for the specified port temporarily until the next switch reset or new
configuration activation. This command also clears port counters.
Authority Admin session except for the Clear operand.
Syntax
set port [port_number]
bypass [alpa]
clear
enable
speed [transmission_speed]
state [state]
Operands
[port_number]
Specifies the port. External ports are numbered 0 and 9; internal ports are numbered 1–8.
bypass [alpa]
Sends a Loop Port Bypass (LPB) to a specific Arbitrated Loop Physical Address (ALPA) or to all
ALPAs on the arbitrated loop. [alpa] can be a specific ALPA or the operand ALL to choose all
ALPAs.
clear
Clears the counters on the port. This operand does not require an Admin session.
enable
Sends a Loop Port Enable (LPE) to all ALPAs on the arbitrated loop
speed [transmission_speed]
Specifies the transmission speed for the specified port. Choose one of the following port speed
values:
1
One gigabit per second
2
Two gigabits per second
4
Two gigabits per second
Auto
The port speed is automatically detected
state [state]
Specifies one of the following administrative states for the specified port:
Online
Places the port online. This activates and prepares the port to send data.
Offline
Places the port offline. This prevents the port from receiving signal and accepting a device
login.
Diagnostics
Prepares the port for testing. This prepares the port for testing and prevents the port from
accepting a device login.
Down
Disables the port by removing power from the port lasers