McDATA 4Gb SAN Switch for HP p-Class BladeSystem User Guide (AA-RW20B-TE, December 2005)

182 Command Line Interface
Table 53 Show Port parameters
Entry Description
AIinit Incremented each time the port begins AL initialization
AIinitError Number of times the port entered initialization and the initialization
failed
Bad Frames Number of frames that have framing errors
ClassXFramesIn Number of class x frames received by this port
ClassXFramesOut Number of class x frames sent by this port
ClassXWordsIn Number of class x words received by this port
ClassXWordsOut Number of class x words sent by this port
ClassXToss Number of times an SOFi3 or SOFn3 frame is tossed from TBUF
DecodeError Number of decode errors detected
EpConnects Number of times an E_Port connected through ISL negotiation
FBusy Number of times the switch sent a F_BSY because Class 2 frame could
not be delivered within ED_TOV time. Number of class 2 and class 3
fabric busy (F_BSY) frames generated by this port in response to
incoming frames. This usually indicates a busy condition on the fabric or
N_Port that is preventing delivery of this frame.
Flowerrors Received a frame when there were no available credits
FReject Number of frames from devices that were rejected
InvalidCRC Invalid CRC detected
InvalidDestAddr Invalid destination address detected
LIP_AL_PD_ALPS Number of F7, AL_PS LIPs, or AL_PD (vendor specific) resets, performed
LIP_F7_AL_PS This LIP is used to re-initialize the loop. An L_Port, identified by AL_PS,
may have noticed a performance degradation and is trying to restore the
loop.
LIP_F8_AL_PS This LIP denotes a loop failure detected by the L_Port identified by AL_PS
LIP_F7_F7 A loop initialization primitive frame used to acquire a valid AL_PA
LIP_F8_F7 A loop initialization primitive frame used to indicate that a loop failure
has been detected at the receiver
Link Failures Number of optical link failures detected by this port. A link failure is a
loss of synchronization or a loss of signal while not in the offline state. A
loss of signal causes the switch to attempt to re-establish the link. If the
link is not re-established, a link failure is counted. A link reset is
performed after a link failure.
Login Number of device logins
Logout Number of device logouts
LoopTimeouts A two (2) second timeout as specified by FC-AL-2
LossOfSync Number of synchronization losses (>100 ms) detected by this port. A loss
of synchronization is detected by receipt of an invalid transmission word.
PrimSeqErrors Primitive sequence errors detected
RxLinkResets Number of link reset primitives received from an attached device