FW V06.XX/HAFM SW V08.02.00 HP StorageWorks SAN High Availability Planning Guide (AA-RS2DD-TE, July 2004)
Table Of Contents
- SAN HA Planning Guide
- Contents
- About this Guide
- Introduction to HP Fibre Channel Products
- Product Management
- Planning Considerations for Fibre Channel Topologies
- Fibre Channel Topologies
- Planning for Point-to-Point Connectivity
- Characteristics of Arbitrated Loop Operation
- Planning for Private Arbitrated Loop Connectivity
- Planning for Fabric-Attached Loop Connectivity
- Planning for Multi-Switch Fabric Support
- Fabric Topologies
- Planning a Fibre Channel Fabric Topology
- Fabric Topology Design Considerations
- FICON Cascading
- Physical Planning Considerations
- Port Connectivity and Fiber-Optic Cabling
- HAFM Appliance, LAN, and Remote Access Support
- Inband Management Access (Optional)
- Security Provisions
- Optional Features
- Configuration Planning Tasks
- Task 1: Prepare a Site Plan
- Task 2: Plan Fibre Channel Cable Routing
- Task 3: Consider Interoperability with Fabric Elements and End Devices
- Task 4: Plan Console Management Support
- Task 5: Plan Ethernet Access
- Task 6: Plan Network Addresses
- Task 7: Plan SNMP Support (Optional)
- Task 8: Plan E-Mail Notification (Optional)
- Task 9: Establish Product and HAFM Appliance Security Measures
- Task 10: Plan Phone Connections
- Task 11: Diagram the Planned Configuration
- Task 12: Assign Port Names and Nicknames
- Task 13: Complete the Planning Worksheet
- Task 14: Plan AC Power
- Task 15: Plan a Multi-Switch Fabric (Optional)
- Task 16: Plan Zone Sets for Multiple Products (Optional)
- Index
Physical Planning Considerations
132 SAN High Availability Planning Guide
Port Connectivity and Fiber-Optic Cabling
This section provides planning recommendations for director and switch port
connectivity and fiber-optic cabling. Recommendations are provided for:
■ Port Requirements
■ Optical Transceivers
■ Extended-Distance Ports
■ High-Availability Considerations
■ Cables and Connectors
■ Routing Fiber-Optic Cables
Port Requirements
Plan for sufficient shortwave laser ports and longwave laser ports to meet the
needs of the SAN configuration. The number of ports required is equal to the
number of device connections (including redundant connections), plus the number
of interswitch links (ISLs) between fabric elements, plus the total number of spare
port connections.
WARNING: Director and switch non-open fiber control (non-OFC) laser
transceivers are designed and certified for use only with fiber-optic cables
and connectors with characteristics specified by HP. Use of other connectors
or optical fiber can result in emission of laser power levels capable of
producing injury to the eye if viewed directly. Use of non-specified connectors
or optical fiber can violate the Class 1 laser classification.
The number of Fibre Channel ports and port operation for directors and switches
are described as follows:
■ Director 2/64 — The director is configured from a minimum of 8 universal
port module (UPM) cards (32 ports total) to a maximum of 16 UPM cards (64
ports total).
UPM cards provide four 2.125 Gbps port connections and can be configured
with shortwave transceivers, longwave transceivers, and extended longwave
transceivers or a combination of all three.