FW 07.00.00/HAFM SW 08.06.00 McDATA SANpilot User Manual (620-000160-230, April 2005)

3
MAP 0600: Port Failure and Link Incident Analysis
3-85
Diagnostics
Figure 3-38 Fabric Binding Dialog Box (First)
b. Ensure the Enable Fabric Binding checkbox is enabled
(checked) for both switches.
c. At the first Fabric Binding dialog box (both switches), click Next.
The second Fabric Binding dialog box displays.
d. At the second Fabric Binding dialog box (both switches), click
Next. The third Fabric Binding dialog box displays.
e. At the third Fabric Binding dialog box, click Activate for each
switch. The fabric binding feature is consistently enabled for both
switches.
f. At the Hardware View for each switch, click Configure and select
Switch Binding and Change State. The Switch Binding - State
Change dialog box displays.
Figure 3-39 Switch Binding - State Change Dialog Box
g. Ensure the Enable Switch Binding checkbox is enabled
(checked) for both switches.