FW V05.01.00-24/HAFM SW V07.01.00-09 HAFM 1U Server SW V07.02.00-09 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CD-TE, September 2003)

Fabric Zoning
161High Availability Fabric Manager User Guide
3. Enter a valid WWN or nickname (if configured) and click OK.
The Find WWN/Nickname dialog box displays (Figure 68). It lists all zones
where the member was found in the right part of the dialog box and zone sets
where the zones were found in the left part of the dialog box. You can click
the zone sets and zones that display in the dialog box to select them.
Figure 68: Find WWN/Nickname dialog box
4. If you want to remove or replace the member in a specific zone or all zones,
click a zone set and zone listed in the to select it. Note that the zone may be in
more than one zone set.
5. Click Remove.
The Remove WWN/Nickname dialog box displays with the a radio button
selected to remove the member from the selected zone.
6. Perform one of the following tasks:
■ Click OK to remove the member from the selected zone.
■ Click the All Zones button to remove the member from all zones in the
library and click OK.
7. To replace the member in a specific zone with another member:
a. Choose a zone set and zone in the Find WWN/Nickname dialog box,
then click the Replace button.
b. When the Replace WWN/Nickname dialog box displays, enter the
WWN or nickname of the member that you want to substitute for the
member in the selected zone, then click OK. The member is replaced with
the one you entered into the dialog box.
Closing the Zoning Library
Choose File > Close to close the Zoning Library dialog box.