FW 07.00.00/HAFM SW 08.06.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CF-TE, March 2005)

HA-Fabric Manager user guide 201
Element Manager Messages
This section lists Element Manager information and error messages in alphabetical order.
Table 24 Element Manager Messages
Message Description Action
A Preferred Path already
exists between this
Source Port and this
Destination Domain ID.
Please re-configure the
desired path.
For any source port, only
one path may be defined
to each destination
domain ID.
On the Add/Change Preferred
Path dialog box, change the
preferred path.
Activating this
configuration will
overwrite the current
configuration.
Confirmation to activate
a new address
configuration.
Click Yes to confirm activating the
new address configuration or No
to cancel the operation.
All configuration names
must be unique.
All address
configurations must be
saved with unique
names.
Save the configuration with a
different name that is unique to all
saved configurations.
All FPM ports will be held
inactive while the director
is configured to
2 Gb/sec speed. Do you
want to continue?
Occurs when FPM cards
are installed in the
director and director
speed is being set to
2Gb/sec in the
Configure Switch
Parameters dialog box.
Replace FPM cards with UPM
cards (UPM cards operate at 1
and 2 Gb/sec) or set the director
speed to 1 Gb/sec.
All port names must be
unique.
A duplicate Fibre
Channel port name was
configured. All port
names must be unique.
Reconfigure the Fibre Channel port
with a unique name.
All port names must be
unique.
A duplicate port name
was entered. Every
configured port name
must be unique.
Reconfigure the port with a unique
name.
An Element Manager
instance is already open.
Only one instance of the
Element Manager can be
open at one time.
Close the open Element Manager
so the desired instance of the
Element Manager can be opened.
Another Element
Manager is currently
performing a firmware
install.
Only one instance of the
Element Manager can
install a firmware version
to the director at a time.
Wait for the firmware installation
process to complete and try the
operation again.