FW 07.00.00/HAFM SW 08.06.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CF-TE, March 2005)

Informational and error messages218
Not all of the optical
transceivers are installed
for this range of ports.
Some ports in the
specified range do not
have optical transceivers
installed.
Use a port range that is valid for
the ports installed.
Open Trunking is not
installed for this product.
Please contact your sales
representative.
The Open Trunking
feature key has not been
enabled. This message
only displays if the
optional Open Trunking
feature is installed.
Enter the feature key into the
Configure Feature Key dialog box
and enable the key. If you require
a feature key, see your account
representative.
Performing this operation
will change the current
state to Offline.
This message requests
confirmation to set the
director offline.
Click OK to set the director offline
or click Cancel to cancel the
operation.
Performing this operation
will change the current
state to Online.
This message requests
confirmation to set the
director online.
Click OK to set the director online
or click Cancel to cancel the
operation.
Performing this action will
overwrite the date/time
on the switch.
Warning that occurs
when configuring the
date and time through the
Configure Date and Time
dialog box, that the new
time or date will
overwrite the existing
time or date set for the
director or switch.
Verify that you want to overwrite
the current date or time.
Periodic Date/Time
synchronization must be
cleared.
Action cannot be
performed because
Periodic Date/Time
Synchronization option is
active.
Click Periodic Date/Time
Synchronization check box in
Configure Date and Time dialog
box (Configure menu) to clear
check mark and disable periodic
date/time synchronization.
Port binding was
removed from attached
devices that are also
participating in Switch
Binding.
Informational message.
You removed Port
Binding from attached
devices, but one or more
of these devices is still
controlled by Fabric
Binding.
Review the Switch Binding
Membership List to determine if the
devices should be members.
Port cannot swap to itself. Port addresses entered in
the Swap Ports dialog
box are the same.
Ensure that address in the first and
second Port Address fields are
different.
Table 24 Element Manager Messages (continued)
Message Description Action