FW 07.00.00/HAFM SW 08.06.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CF-TE, March 2005)

HA-Fabric Manager user guide 67
3. On the Address Properties dialog box, click the Product Type and Access tab.
Figure 30 Address Properties dialog box (Product Type and Access tab)
4. Select the type of device from the Product Type drop-down list.
5. If you select <not specified> from the Device Type drop-down list, go to step 16.
6. If you select Switch from the Device Type drop-down list, go to step 14.
7. Enter a user ID in the User ID field.
8. In the Password and Retype Password fields, enter the password.
9. Click OK.
Configuring the SNMP agent
This section provides information to help you use the simple network management protocol (SNMP)
agent module.
Setting up the SNMP agent
The SNMP agent module implements the objects defined in the Fibre Channel Management
(FCMGMT) Management Information Base (MIB) 3.1 and a small number of objects defined in
MIBII. Through implementation of these MIB objects, the agent translates information stored on the
appliance into a form usable by SNMP management stations.
You can configure network addresses and community names for up to 12 SNMP trap recipients.
SNMP sends messages for specific events that occur on the appliance to trap recipients.