FW 07.00.00/HAFM SW 08.06.00 HP StorageWorks HA-Fabric Manager User Guide (AA-RS2CF-TE, March 2005)

Managing the HAFM application68
Figure 31 shows the dialog box used to configure the SNMP agent.
Figure 31 SNMP Agent Setup dialog box
Turning the SNMP agent on or off
To turn the SNMP agent on or off, select Monitor > SNMP Agent > On | Off from the HAFM
menu bar.
Configuring trap recipients
To configure the SNMP agent that runs on the appliance and implements the Fibre Alliance MIB,
perform the following:
1. Select Monitor > SNMP Agent > Setup from the HAFM menu bar.
The SNMP Agent Setup dialog box opens (Figure 31).
2. Click the Trap Recipients tab.
3. Select Enable Authorization Traps if you want to enable messages to be sent when
unauthorized management stations try to access SNMP information through the appliance.
4. Click Add.
The Add Trap Recipient dialog box opens (Figure 32).
Figure 32 Add Trap Recipient dialog box
5. If you want this trap recipient to be active, select the Activate check box.
6. Enter the IP address or DNS host name of the trap recipient in the IP Address box.
This name must be 64 characters or fewer.