958-000324-002, March 2005)

b. Measure and record the depth of the right side of the cabinet from the

inside of the front vertical rack-mounting standard to the inside of the

rear vertical rack-mounting standard.

3. Using a #2 Phillips screwdriver and eight (8) of the ten pan-head Phillips

screws (#10 x 1/2) and, if you are installing the server in an HP 9000, 10000

or 11000 rack, eight (8) square alignment washers, attach four (4) three-hole

bar nuts to the rack-mounting standards as follows:

a. Aligneachthree-holebarnutwiththerack-mountingstandardasshownin

Figure 5. Ensure each bar nut is mounted with the n arrow side (drilled

holes-to-edge side) facing the inside of the cabinet.

Figure 5 Three -hole bar nut alignment

NOTE:

Ensure the bar nut screw washers to do not overlap the inside edges of

the rack-mounting standards and mounting brackets. Washer overlap may

interfere with slide rail operation.

Installation