958-000324-002, March 2005)

NOTE:

Figure 5 depicts the right-side rails of the cabinet. This figure does not depict

thesquarealignmentwashersrequiredifyouareinstallingthebarnutsin

an HP 9000, 100 00, or 11000 series cabinet.

b. Attach each bar nut using two screws (first and t hird holes) per nut.

NOTE:

If you are installing the bar nuts on an HP 9000, 10000, or 11000 series

cabinet, add a square alignment washer to each screw, orienting the

protruding alignment bumps with the rack-mounting standard.

c. Partially tighten ea ch screw, le aving enough space for the front and rear

bracket flanges to insert between the rack-mounting standards and bar

nuts.

4. Depending on the cabinet depth measured in step 2, attach each front bracket

to a rear (short or long) bracket. If the cabinet depth is under 22 inches, use

one front bracket and one short rear bracket. If the cabinet depth is over 22

inches, use one front bracket and one long rear bracket.

Be su re to choose the slots in the rear bracket which will result in the length

of the c ombined fro nt and rear bracket to match the cabinet depth measured

in step 2.

a. Using a #2 Phillips screwdriver and two (2) flat-head Phillips machine

screws (#8 x 7/16 ) per bracket assembly, conne ct a front and rear bracket

together with a two-hole bar nut as s hown in Figure 6.

HP StorageWorks HA-Fabric Manager Appliance installation guide F W07.00.00/HAFM

SW 08.06.00