958-000324-002, March 2005)

Figure 7 Bracket installation

a. Slide the mounting bracket flanges between the bar nuts and rack-mounting

standards. Adjust the overall length of each bracket assembly if required.

b. To allow tolerance for HA FM appliance installation, tighten the three-hole

bar nut screws (bracket-to-rack mounting standard) so the brackets are

stable, but can be moved laterally.

NOTE:

Ensure the bar nut screw washers to do not overlap the inside edges of

the rack-mounting standards and mounting brackets. Washer overlap may

interfere with slide rail operation.

c. Using a #2 Phillips screw driver, securely tighten the bar nut screws (two

perbracketassembly,fourtotal)thatconnectthefrontandrearbrackets.

Installing slide rails

To attach the left and right slide rails to the HAFM appliance:

HP StorageWorks HA-Fabric Manager Appliance installation guide F W07.00.00/HAFM

SW 08.06.00