958-000324-002, March 2005)

Figure 9 Appliance installation

3. Using a #2 Phillips screwdriver, securely tighten the bar nut screws (four per

assembly, eight total) that connect the bracket assemblies to the rack -mo unting

standards.

4. Install one hexagonal-nut standoff per side (t wo total) to prevent the HAFM

appliancefrommoving. AtthefrontoftheHAFMapplianceasshownin

Figure 10, screw a standoff through the remaining (center) hole where each

three-hole bar nut attaches to the rack-mounting standard. Secure each standoff

witha5/16open-endwrench.

NOTE:

If you are installing the server in an HP 9000, 10000, or 11000 series rack you

will also need to install a square alignment washer with each hexagonal-nut

standoff.

5. As shown in Figure 10, use the two (2) remaining pan-head Phillips screws

(#10 x 1/2) to secure the HAFM appliance rack-mount ears (factory-installed

on the HAFM appliance) to the hexagonal-nut standoffs. Secure the screws

with a #2 Phillips screwdriver.

HP StorageWorks HA-Fabric Manager Appliance installation guide F W07.00.00/HAFM

SW 08.06.00