958-000324-002, March 2005)

1. As shown in Figure 11, connect the AC power cord to the HAFM appliance

and to a facility power source or rack power strip that provides single-phase,

90 to 264 VAC current.

When the power cord is connected, the HAFM appliance powers on and

performs power-on self-tests (POSTs). During POSTs:

a. The green liquid crystal display (LCD) panel illuminates.

b. The green hard disk drive (HDD) LED blinks momentarily, and processor

speed and random-access memory information display momentarily at

the LCD panel.

c. After a few seconds, the LCD panel displays the following message

pertaining to boot sequence selection (Figure 12):

Figure 12 LCD pan el during boot sequence

d. Ignore the message. After ten seconds, the HAFM appliance performs the

boot sequence from the basic input/output system (BIOS). During the boot

sequence, the HAFM appliance per forms additional POSTs a nd displays

the following operational information at the LCD panel:

•Hostname.

• System date and time.

• LAN 1 and LAN 2 Internet Protocol (IP) addresses.

• Rotational speed status on multiple HAFM appliance fans.

• Central Processing Unit (CPU) Temp

• Hard disk capacity

• Virtual and physical memory capacity

After s uccessful boot and POST completion, the LCD panel displays a

Welcome!! message.

2. Press the left edge (PUSH label) of the LCD panel to disengage the panel

and expose the CD-RW drive.

3. Insert a blank rewritable CD into the CD-RW drive and close the LCD panel.

HP StorageWorks HA-Fabric Manager Appliance installation guide F W07.00.00/HAFM

SW 08.06.00