958-000324-002, March 2005)

3Conﬁguration

Configuring H AFM appliance password and

network addresses

Verify the type of LAN installation with the customer’s network administrator. If the

HAFM appliance o

r equipment cabinet is installed on a dedicated L AN, network

information does not require change. Change the default password for the appliance’s

LCD panel (if required by the customer) , then go to Configuring additional HAFM

appliance information.

If the HAFM appliance is installed on a public LAN segment, change the default

password for the HAFM appliance’s LCD panel and the following transmission control

protocol/internet protocol (TCP/IP) network information to conform to the customer’s

LAN addressing scheme:

• IP address.

• Subnet mask.

NOTE:

At some customer installations, TCP/IP addresses for the HAFM appliance may be

allocated

automatically using dynamic host configuration protocol (DH C P).

Configur

ing LCD panel password

To configure a new LC D panel password at the HAFM appliance:

1. At the LCD panel, press ENTER. The Welcome!! or o perational information

message changes to the following (Figure 13):

HP StorageWorks HA-Fabric Manager Appliance installation guide F W07.00.00/HAFM

SW 08.06.00